LED Driver Ul – Explore This Site Now To Find Out Further Answers..

If you are planning on installing LED strip lights (also referred to as LED tape) you need to be able to accurately calculate the power required. Having insufficient power source will lead to only some (or none) of the LEDs illuminating, or can cause irritation flicker. An over specified power supply will surely cost more to buy, and will also be harder to fit as they are bigger.

To calculate the energy supply required for your LED driver, you need to know: Length of the strip or tape, Variety of LEDs per metre, Power consumption per LED. To calculate the size of power supply (in Amps) you should multiply the length of the LED tape by the amount of the LEDs per metre and after that multiply this by the strength of the LED (.08w to .24w per LED are typical values). Then divide the benefit by 12 volts to calculate the necessary Amperage of the power source.

(Length of LED Strip x LEDs per Metre x LED Power) / 12 We recommend you add at the very least 10% for the calculated value to permit for resistance and losses in the cables. You would should also permit any possible expansions or additions down the road. Most LED Strip Lights might have additional sections added using joining cables.

Calculation Examples: Example 1: A 5m roll of SMD3528 (.08w) with 60LED/m will be: (5m x 60 x .08) / 12 = 2amps 10% = 2.2Amps. Example 2: A 5m roll of SMD5050 with 60LED/m would be: (5m x 60 x .24) / 12 = 6amps 10% = 6.6Amps.

For virtually any LED strips over 2 metres long it is possible to offer a 12volt feed to both ends from the strip a treadmill feed in the middle, by cutting the strip into two and connecting the ability supply to both strips. This gives a far more even power distribution and should give a more consistent illumination.

LED Strip Light Uses – There are two premiere factors behind using LED strips. The first is efficiency – LEDA driver 12v are incredibly efficient, with the majority of the power planning to produce light, not heat. Their extremely longevity (20,000 hours is typical) signifies that additionally they do not need replaced very often, ultimately causing vastly reduced lifetime costs.

Another reason is aesthetic. Leds can be created extremely small – some LED lighting strips are as thin as 4mm – and thus could be installed in places where traditional lights would not fit. Increase this the different LED colour options, including RGB LEDs with remote controlled colour changing abilities. This provides a new range of possible lighting effects that can dramatically change the appearance of a room.

Unlike other traditional lights which require bundles of cables and drain lots of power, Leds are far easier to use and easy to put in. The cluster of those miniature size lighting is fixtures manufactured in such hapmys efficient way they are capable of illuminating any area of your choice. Installing Leds inside your commercial or residential application can help keep environment green, save your valuable energy cost and above all, causes you to a brilliant owner who follows most advanced technology trends.

Every lighting technologies have some attributes that determines its nature and requirements of installation. Similar is the case with LED, you should think, decide and plan precisely to get LED Waterproof power supply properly installed in your area. LEDs uses are versatile and thus its type and specifications can also be varied in accordance to the application. LEDs are applicable within both dry and wet areas, learning the proper fixture readily available for each will surely help make your installation process easier.